S3E1 Main Electrical Service Panel Installation
Trending Episodes
•
11m
A rainy day sets the stage for installing a 200 amp main electric service panel. The process includes setting up the panel, installing conduit, and following NEC code for guidance. A heat gun bends the conduit, and ground wire is connected. Wiring connections are made, including neutral and hot wires, and a GFCI circuit breaker is installed. After passing inspection, a second ground rod is added for proper grounding.
Up Next in Trending Episodes
-
S3E12 Pouring a Small Concrete Slab f...
The project starts with installing an HVAC system for both upstairs and downstairs. A concrete slab is prepared for outdoor units, with careful attention to dimensions and securing methods. A concrete mixer is used to achieve the right consistency for the pour. Challenges during pouring include t...
-
S3E14 Installing a Very Efficient Duc...
The installation of the Mr Cool Universal System, a ducted split heat pump, starts with planning the duct work and line sets using specialized software. Concrete pads are prepared for stability, and the air handler's build quality is highlighted for its efficiency. Insulation materials are discus...
-
S3E15 Drain & Vent Pipe Rough-In
Plumbing installation starts with understanding gravity and pipe routing. It includes drain plumbing for heating and main stacks, integrating radon and toilet stacks. A PowerPoint plan addresses venting with air mittens valves. Proper gluing and clean joints are crucial. Challenges in fitting and...
